Exam 27 December 2019, Cisco CCDP 300-101 questions and answers - Implementing Cisco IP Routing PDF

Title Exam 27 December 2019, Cisco CCDP 300-101 questions and answers - Implementing Cisco IP Routing
Course IT Infrastructure Management
Institution Charles Sturt University
Pages 7
File Size 455.1 KB
File Type PDF
Total Downloads 37
Total Views 135

Summary

Implementing Cisco IP Routing...


Description

https://www.lead4pass.com/300-101.html 2019 Latest lead4pass 300-101 PDF and VCE dumps Download

300-101Q&As Implementing Cisco IP Routing

Pass Cisco 300-101 Exam with 100% Guarantee Free Download Real Questions & Answers PDF and VCE file from: https://www.lead4pass.com/300-101.html

100% Passing Guarantee 100% Money Back Assurance Following Questions and Answers are all new published by Cisco Official Exam Center

300-101 PDF Dumps | 300-101 Study Guide | 300-101 Braindumps

1/7

https://www.lead4pass.com/300-101.html 2019 Latest lead4pass 300-101 PDF and VCE dumps Download

QUESTION 1 Which two statements about DMVPN are true? (Choose two.) A. IPsec encryption not supported with statically addressed spokes. B. t requires full-mesh connectivity on the network. C. It uses NHRP to create a mapping database of spoke addresses D. Multicast traffic is not supported E. It supports dynamic addresses for spokes in a hub-and-spoke VPN topology. Correct Answer: AC

QUESTION 2 Where must a network engineer configure the ip helper-address command on a router? A. On the interface that will receive the broadcasts B. On the DHCP configuration C. the interface that is closed to the destination DHCP server D. on the global configuration mode Correct Answer: A

QUESTION 3 Which NAT command do you enter to disable dynamic ARP learning on an interface? A. R1(config-if)#ip nat enable B. R1(config-if)#ip nat inside C. R1(config)#ip nat serive D. R1(config-if)#ip nat outside E. R1(config)#ip nat allows-static-host Correct Answer: E

QUESTION 4 Which statement describes the difference between a manually configured IPv6 in IPv4 tunnel versus an automatic 6to4

300-101 PDF Dumps | 300-101 Study Guide | 300-101 Braindumps

2/7

https://www.lead4pass.com/300-101.html 2019 Latest lead4pass 300-101 PDF and VCE dumps Download

tunnel? A. A manually configured IPv6 in IPv4 tunnel allows multiple IPv4 destinations. B. An automatic 6to4 tunnel allows multiple IPv4 destinations. C. A manually configured IPv6 in IPv4 tunnel does not require dual-stack (IPv4 and IPv6) routers at the tunnel endpoints. D. An automatic 6to4 tunnel does not require dual-stack (IPv4 and IPv6) routers at the tunnel endpoints Correct Answer: B

QUESTION 5 Refer to the exhibit. A new TAC engineer came to you for advice. A GRE over IPsec tunnel was configured, but the tunnel is not coming up. What did the TAC engineer configure incorrectly?

300-101 PDF Dumps | 300-101 Study Guide | 300-101 Braindumps

3/7

https://www.lead4pass.com/300-101.html 2019 Latest lead4pass 300-101 PDF and VCE dumps Download

A. The crypto map is not configured correctly B. The crypto ACL is not configured correctly. C. The crypto map is not applied to the correct interface. D. The OSPF network is not configured correctly. Correct Answer: B

QUESTION 6 A network engineer wants to ensure an optmal end-to-end delay bandwidth product. The delay is less than 64KB. Which TCP feature ensures steady state throughput? A. Window scaling B. Network buffer C. Round-trip timers D. TCP acknowledgments Correct Answer: A

QUESTION 7 Which option must be configured on a target device to use time stamping to accurately represent response times using IP SLA? A. Responder B. Jitter value C. TCP Connect D. ICMP Echo Correct Answer: D http://www.cisco.com/c/en/us/td/docs/ios/12_4/ip_sla/configuration/guide/hsla_c/hsoverv.html

QUESTION 8 When unicast reverse path forwarding is configured on an interface, which action does the interface take first when it receives a packet? A. It check the ingress access list

300-101 PDF Dumps | 300-101 Study Guide | 300-101 Braindumps

4/7

https://www.lead4pass.com/300-101.html 2019 Latest lead4pass 300-101 PDF and VCE dumps Download

B. It check the egress access list C. It verifies that the source has a valid VEF adjacency D. It verifies a reverse path via the FIB to the source Correct Answer: D When a packet is received at the interface where Unicast RPF and ACLs have been configured, the following actions occur: Step 1: Input ACLs configured on the inbound interface are checked. Step 2: Unicast RPF checks to see if the packet has arrived on the best return path to the source, which it does by doing a reverse lookup in the FIB table

QUESTION 9 which the Valid range for BGP private ASNs? A. 64512-65535 B. 62464-65024 C. 64512-65024 D. 62464-64511 Correct Answer: A

QUESTION 10 In IPv6, the interfaces running OSPF can be configured with multiple address prefixes.Which statement is true about the IPv6 addresses that can be included into the OSPF process? A. Specific addresses can be selected using a route map. B. Specific addresses can be selected using an ACL. C. Specific addresses cannot be selected for importation into the OSPF process. D. Specific addresses can be selected using a prefix list. Correct Answer: C

QUESTION 11 On a Frame relay, we are unable to ping the remote router, how to solve the problem?

300-101 PDF Dumps | 300-101 Study Guide | 300-101 Braindumps

5/7

https://www.lead4pass.com/300-101.html 2019 Latest lead4pass 300-101 PDF and VCE dumps Download

A. DLC is active B. DLC is not active and deleted C. Frame Relay map is configured D. Need and ACL to allow PING Correct Answer: C

QUESTION 12 You want to configure a device to select an OSPF-learned route as the preferred path over an EBGP-learned route Which action must you take? A. Increase the OSPF cost B. Decrease the OSPF cost C. Increase the OSPF administrative distance D. Decrease the OSPF administative distance Correct Answer: D

QUESTION 13 Which three methods can a network engineer use to fix a metric based routing loop in the network? A. A.Implement offset lists at network boundaries B. B. Filter routes manually using distribute lists C. C. Filter routes manually using prefix lists D. D. Implement proper network summarisation on key routing points E. E. Filter routes based on tags F. F. Utilise root database filters Correct Answer: ABE

300-101 PDF Dumps

300-101 Study Guide

300-101 PDF Dumps | 300-101 Study Guide | 300-101 Braindumps

300-101 Braindumps

6/7

https://www.lead4pass.com/300-101.html 2019 Latest lead4pass 300-101 PDF and VCE dumps Download

To Read the Whole Q&As, please purchase the Complete Version from Our website.

Try our product ! 100% Guaranteed Success 100% Money Back Guarantee 365 Days Free Update Instant Download After Purchase 24x7 Customer Support Average 99.9% Success Rate More than 800,000 Satisfied Customers Worldwide Multi-Platform capabilities - Windows, Mac, Android, iPhone, iPod, iPad, Kindle

We provide exam PDF and VCE of Cisco, Microsoft, IBM, CompTIA, Oracle and other IT Certifications. You can view Vendor list of All Certification Exams offered: https://www.lead4pass.com/allproducts

Need Help Please provide as much detail as possible so we can best assist you. To update a previously submitted ticket:

Any charges made through this site will appear as Global Simulators Limited. All trademarks are the property of their respective owners. Copyright © lead4pass, All Rights Reserved.

300-101 PDF Dumps | 300-101 Study Guide | 300-101 Braindumps

7/7...


Similar Free PDFs